Recent content by CBJeeper

Perfect. That is a plan. Just need to figure out all the pieces now. I gather you did the same at the fuel rail disconnect? Just used a compression fitting there as well?

My 1990 has quick connects at the fuel rail and is crimped at the frame.

So you cut off the original hose crimps at the unit frame and used 5/16" compression fittings adapted to 6AN hose fittings? How did you connect at the fuel rail? Any photos available?

I have read various posts and looked at videos but still have little understanding of the correct approach to use when replacing rubber fuel delivery and return lines at the engine. Both lines use disconnects at the fuel rail and both hoses have crimped connectors where they attached to the hard...

1990 Wagoneer with a BDS 3" lift. Core 4x4 LCAs and UCAs. New spring packs in rear. I purchased Goodyear Wrangler Authority 31/10.50-15LT Load C tires. I am considering a 15x7 DX4 wheel with 4.59 backspacing and +15 offset. Is this wheel suitable? I really want forum feedback prior to purchasing.

Update. So I have decided to go with the Goodyear Wrangler Authority A/T 31/10.50-15 from Wally World. I am looking at a 15 x 7 wheel that has 4.59 BS and +15 offset. Does anyone have knowledge on the feasibility of this combo?

Any clearance issues?

1990 Wagoneer Limited- I am installing a BDS 3" lift with new spring packs, Nitro shocks, and Core 4x4 Cruiser adjustable lower and upper control arms, as well as Grand Cherokee steering components. I want to update the wheels and tires. I have the factory 3:55 gearing. I would rather not...

I would like to see pics of your Waggy.

I will be purchasing tires for my soon -to-be 3" BDS lifted 1990 Wagoneer. I am looking at 30" x 9.5 or 235/75-15. The later seems to typically be a 28-29" tire. I am wondering if you'all are running LT load C tires or P series? I am trying to keep weight down as best possible, but am wondering...

This is perfect. Thank you for sharing!

Ues, the Core 4x4 arms will provide all the adjustment needed. My intent is to get the setup as close as possible and then let the allignment shop dial it in.

Much appreciated!

I searched this topic and found some information on setting UCA and LCA lengths but am still left wanting more. I have a 90 Wagoneer Limited on which I am installing a BDS 3" lift with new spring packs in the rear. I am also installing Core 4x4 upper and lower adjustable control arms. I read...

1990 Wagoneer My XJ's door chime will come on about 30 minutes after the engine has been running and only stops when I run the engine again. Reading other posts, I targeted my attention on the door switches. The front passenger switch wires had copper showing so I repaired with electrical tape...